In this case you have to install the driver files manually which will be described in the following step 3. If you did not see any message popping up at all, check you Windows device manager if the interface driver has been installed correctly. To access the device manager under windows type devmgmt. Then click on device manager in the upper left corner of the appearing window. This entry must disappear when you disconnect the Interface from the PC and re-appear when you connect it again.
If there is only an entry marked with an yellow "! Extract the content of the file to your harddisk here we extracted it to drive C:. Go to the extracted folder and start one of the included setup files. Proceed through the installer by accepting the license agreement and clicking "Next" and "Install". Firmware update. You can use it to do all the configuration from the computer or smartphone, to backup settings, load preconfigured setups and do a lot more. The latest StudioX version is 3.
Please make sure to always use the latest version in order to be compatible with latest device firmware updates. If not already done you can get StudioX here: StudioX 3. The file is included in the StudioX installation folder. Also you can get this from the Microsoft website or by using the Windows Update functionality.
Check the notifications of your Windows system:. If you did not see any message popping up at all, check you Windows device manager if the interface driver has been installed correctly. To access the device manager under windows type devmgmt. You must be able to find following entry:. Connect the servo wire coming from your USB interface to this port.
Make sure to connect the wire in correct polarity on both sides! Watch out for correct polarity! For firmware V5. StudioXm iOS. StudioXm Android. Manual Microbeast PLUS flybarless system has available some different versions, each version has different programming and function, please make sure your Microbeast version and read its correct manual carefully before assembly or upgrading, especially you are upgrade from version V3. For firmware V4.
For firmware V3. Added separate trim values for aileron, elevator, collective and rudder. Reworked adjustment in Receiver Menu: Receiver Menu Point A: automatic receiver type detection; see manual for further information. Receiver Menu Point A: changed LED colors for receiver types and also changed receiver type naming; see manual for further information. Reworked adjustment in Setup Menu: In general values and presets are changed using the rudder stick; menu options selecting servos, changing adjustment positions are set with aileron; when directions are setup correctly, left stick decreases a value and right stick increases a value.
Setup Menu Point J Cyclic throw : measurement and neutral positions can be selected as often as you like now, so you can even check positions after the setup was finished; see manual for further information.
Setup Menu Point K Collective pitch : no need to teach the stick end positions anymore, instead the user has to adjust the pitch range initially so the stick movement and range is shown correctly on the display; see manual for further information. Setup Menu Point M Cyclic directions : no need to check swash gyro compensation by user anymore, instead teach the stick directions to the system; see manual for further information.
Reworked settings in Parameter Menu: Parameter Menu Point A Quick trim : added collective trim and rudder trim can be done with rudder stick now; see manual for further information.
Limited function of control loop when heli is standing on the ground and prevents the heli from tilting by accident during take-off. Added governor rpm display when switching into idle up showing the set rpm and actual rpm, giving a better clue to see if TX is setup correctly and what rpm the system is sensing see: Governor Usage V4. More sensitive soft start for electric drives.
0コメント